Conveying Dried Biosolids: Dust, Heat, and a Material That Behaves Nothing Like Cake

Conveying Dried Biosolids: Dust, Heat, and a Material That Behaves Nothing Like Cake

Plants add thermal dryers for good reasons: a Class A product, a fraction of the hauling tonnage, and a material that can be stored and marketed instead of land-applied on someone else’s schedule. What comes out of the dryer, though, is not cake with less water in it. It is a different material, and the conveyors that handled cake for twenty years are usually the wrong machines for it.

What Leaves the Dryer

Dried biosolids are hot, granular, dusty, and free-flowing. Where cake sticks, dried product slides and spills. Where cake is inert, dried product is organic dust with a low ignition energy and a known tendency to self-heat in storage. Temperature at the dryer discharge is far above anything a cake conveyor was specified for, and the product keeps shedding fines at every point it is dropped, turned, or scraped. The handling problems move from adhesion and carryback to containment, heat, and fire.

Design Changes That Matter

Contain everything. Dried product should run in enclosed conveyors from dryer discharge to storage, with dust collection at the points where material enters and leaves. Open belts are a dust source along their whole length. The Pathwinder conveyor is enclosed-capable and can run a single sealed path from dryer to silo without intermediate transfers, which matters because every transfer is a dust generator.

Rate for the temperature. Belting, wear surfaces, seals, and anything in contact with product has to be specified for the dryer outlet temperature, and the conveyor route often needs to allow for product cooling before storage. A conveyor that carries hot product into a silo is building a self-heating problem for the storage system to discover later.

Minimize drops. Fines are generated at impacts. Fewer transfer points, gentle discharge geometry, and chutes designed so product moves rather than tumbles all reduce the dust load. This is the same argument made in the lime-stabilized post, with higher stakes.

Treat it as a combustible dust application. Enclosures, electrical equipment, bearings, and monitoring in a dried biosolids system fall under combustible dust requirements that cake systems never had to meet. Temperature sensing at bearings and in enclosed sections, spark and heat detection where the code authority requires it, and interlocks that stop feed on a high-temperature alarm are design items, not retrofits. Confirm the applicable standards with the plant’s code authority and insurer early.

Storage and Loadout Are Part of the System

Dried product is stored in silos or hoppers and loaded into trucks or bags for distribution. Even filling and reliable discharge matter more than with cake, because dried product bridges and rat-holes in storage and because a uniformly filled trailer is the difference between a marketable product and a dusty one. The Flight Distribution conveyor spreads product across a storage bay or trailer; for discharge points that move, the Flex-End Discharge adds positions across a 12-foot arc.

Plan the Conveyor With the Dryer, Not After It

Most dried biosolids conveying problems trace back to a dryer procured first and the material handling scoped later against the existing layout. The conveyor route, enclosure, temperature rating, and dust control are cheapest when designed with the dryer and most expensive when added after the first startup. If your plant is adding a dryer, or already fighting dust and heat downstream of one, send the dryer data and the layout through our free engineering review and Serpentix engineers will design the product handling as part of the dryer project.

Facebook
Pinterest
Twitter
LinkedIn

Ready to Apply These Insights?

Tell us about your facility—we’ll design a solution that meets your needs.

Proudly Made in the USA –

Compliant with BABA Regulations

Serpentix is fully compliant with the Build America, Buy America Act—ensuring high-quality, American-made materials for federally funded projects.